DAS NX-148E LCD Codepad Manual de Instalação

Table of ContentsEntering the Program Mode...2Selecting the Module to Program...2Programming a Loc

10ExpansionPower TroubleExpansionLow BatteryExpanderBox TamperExpansionOver-currentExpansionTroubleExpansionSiren troubleZoneTamper, Press UZoneLow Ba

11NX-124 MAXIMUM WIRE RUN(Note: These numbers are for one keypad at the end of the wire. When connecting more than one keypad to theend of the wire,

SPECIFICATIONSOPERATING POWER 12 VDC RegulatedSupplied by NX-8 or NX-320OPERATING TEMPERATURE 32 to 120 degrees FCURRENT DRAW 110 mA Maximum 75

2ENTERING THE PROGRAM MODETo enter the Program Mode, press [U]-[8]. At this time, the LCD screen will prompt you for the programming code.Next, ente

3ABCDEFGH I JKLMNOPQRSTUVWXYZ [ ¥ ] ^ _ `abcdefghi jklmnopqrstuvwxyz{|}  !"#$%&' ( )U +, - . /0123456789: ;<=>?@•  ä  µ  

4[U]-[9]-[2] PROGRAMMING CUSTOM MESSAGES IN THE KEYPADNOTES: The messages (custom, zone, and shutdown) are transferred to other LCD keypads after thi

5Open 759/25 17:57 P3U[U]-[9]-[4] SET KEYPAD NUMBER AND PARTITION1) Enter [U]-[9]-[4]The LCD screen wi

6[U]-[0] ADJUST KEYPAD TONE1) Press [U]-[0]The LCD screen will prompt you to use the scroll keys located onthe right of the display to raise or lower

74) Enter a partition number. Note: The defaultallows access to all partitions. The firstkeypress will remove access to the partition.To reestablish

8Ready 12345678Armed 1234-678System ReadyType code to arm12-45-78 Disarm --3 67- Arm 12-4- -78

9Area 5 ReadyType code to armService RequiredType U2 for helpControlOver CurrentControlSiren TroubleControlBox TamperControlPhone TroubleControlFail t